TEG5328P-24-410W L3 Managed PoE Switch
Layer-3 Routing Engine,High-Efficiency Fast Forwarding
Supports Layer 3 www routing protocols, supports Layer 3 forwarding of up to 400+ terminals, easily meets Layer 3 routing and forwarding across network segments, and truly achieves Layer 2 network isolation and Layer 3 network interworking. Compared with using a Layer 2 switch for transmission, there is no need to go through a router, and the forwarding speed is faster!
370W Smart PoE Power Supply, 2 Times Load CapacityUsing a new 410W built-in PoE power, the number of AF / AT full-supply loads is twice than the ordinary low-power PoE switches!At the same time, the built-in PSE chip with intelligent power management function can monitor the temperature of the chip and customize the PoE power supply based on the time period. The device will automatically turn on / off the PoE function during working hours and idle time to minimize energy consumption and extend the service life of the device.
Flexible QoS, Precise Traffic ControlThe TEG5328P-24-410W supports three QoS scheduling modes (SP, SWRR, WRR) for more accurate traffic control. After the QoS function is enabled, the traffic in the network will be precisely controlled according to the priority of the label. It will prioritize important traffic and reduce the proportion of data flows that occupy a large amount of insignificant traffic in the condition of limited bandwidth,in order to better meet the current transmission needs.
Supports Layer 2 And Layer 3 ACL,For More Secure AccessSupport strict access control based on MAC address or IP address, which can filter the corresponding data packets to enhance user network security. It can be used for network deployment of enterprise medical and other units.
Multiple Attack Defenses.Support IP / MAC / ARP filtering / DoS attack protection, enable attack protection according to networking requirements, bring multiple layers of protection to user network security, and ensure network stability and failure-free.
6kV Lightning Protection.
Hardware
|
Network standards
|
IEEE802.3 IEEE802.3u IEEE802.3ab IEEE802.3z IEEE802.3x IEEE802.3af/at IEEE802.1p IEEE802.1q IEEE802.1w IEEE802.1d IEEE802.1s
|
|
LED Indicator
|
1*Link/Act or PoE LED indicator 1*Link/1*Link/Act mode converting LED indicator 1*PoE mode converting LED indicator 1*PoE Max LED indicator 1*Power LED indicator 1*SYS LED indicator
|
|
Interfaces
|
24*10/100/1000 Base-T Ethernet ports 4*1000 Base-X SFP ports 1*Console port
|
|
Transmission media
|
Recommended: CAT5/5e UTP or better
|
|
Fan quantity
|
2
|
|
Level of protection
|
Lightning protection for ports: 6kV Lightning protection for power: 6kV ESD: Air discharge: ±10kV Contact discharge: ±8kV
|
|
Forwarding mode
|
Store-and-forward
|
|
Switch capacity
|
56Gbps
|
|
Packet forwarding rate
|
41.70Mpps
|
|
Buffer
|
12Mb
|
|
MAC address table
|
16K
|
|
Jombo frame
|
10K
|
|
PoE power supply management
|
Support
|
|
PoE budget
|
Single port: AF: 15.4W, AT: 30W Whole device: 370W
|
|
Input voltage
|
100-240V AC 50/60Hz
|
|
Power consumption
|
Full load: <432W Empty load: <23W
|
|
Dimension
|
440.0mmx284.0mmx44.0mm
|
|
Mounting
|
Desktop mounting: support Wall mounting: support Rack mounting:non-support
|
|
Energy Efficient
|
Support
|
|
Environment
|
Operating temperature: 0°C - 45° Storage temperature: -40°C - 70°C Operating humidity: (10% - 90%) RH, non-condensing Storage humidity: (5% - 90%) RH, non-condensing
|
|
Certification
|
FCC-CE -RoHS
|
Software
|
L3 Features
|
Supports VLAN-based routing Supports IPv4 static routing Supports static ARP
|
|
PoE power supply management
|
Supports port PoE configuration and power supply with priority Supports PoE over-temperature protection Supports PoE scheduled management Supports intelligent management and PoE-powered device detection (port status, power assignment and PoE-powered device status)
|
|
Security features
|
ARP receiving limit Unknown MAC address discard DoS attack defense 802.1x security authentication Radius security authentication
|
|
VLAN
|
IEEE 802.1Q VLAN VLAN Layer-3 interfaces Supports three port modes: Access, Trunk and Hybrid
|
|
DHCP Server
|
DHCP Relay DHCP Snooping Supports Option 82 policy configuration
|
|
Port aggregation
|
Static aggregation LACP dynamic aggregation
|
|
Spanning tree
|
IEEE 802.1d STP (Spanning Tree Protocol) IEEE 802.1w RSTP (Rapid Spanning Tree Protocol) IEEE 802.1s MSTP (Multiple Spanning Tree Protocol) Supports edge port Supports BPDU statistics
|
|
Multicast
|
IGMP Snooping V1/V2/V3 Supports port fast leave
|
|
Port Mirroring
|
Supports N: 1 port mirroring
|
|
Quality of Service
|
SP (Strict Priority) SWRR (Simple Weighted Round Robin) WRR (Weighted Round Robin) Supports 802.1p port trust mode Supports DSCP port trust mode Supports a maximum of 8-queue service quality mapping
|
|
ACL
|
Supports MAC ACL and IP ACL
|
|
Loading and upgrade
|
Supports FTP/TFTP/HTTP upgrade Supports configuration import and export
|
|
Management and maintenance
|
Supports Telnet Supports Telnet, Console Supports SNMP V1/V2/V3 Supports WEB management and maintenance Supports Ping/Tracert/Connection Detection CPU Monitoring and memory monitoring
|